|
|
3/8 X 3-1/4 INCH T-ANCHOR
|
|
Prescott Supply Price: $4.62
Item Number: 3TA38314
Order quantities in the range below to receive Discount(s):
| Quantity | Amount |
| 5 to 12 | $3.23 |
| 13 to 24 | $2.31 |
| 25 to 49 | $1.39 |
| 50 or more | $0.92 |
|
|
|
The DFS T-Anchor has a gravity activated toggle
head for use in hollow walls and ceilings.
Can be used in concrete, steel and wood.
|
|
What advantages are there? |
- Same drill bit diameter as anchor diameter.
- T-Anchors can be used in concrete block, wood, steel or and any
hollow space application.
- Smaller hole requirements than toggle bolts
- May be used in hollow block walls and ceilings
- One size hole to drill... No realigning of holes is necessary
- Zinc & dichromate plated for corrosion resistance
- Nuts & washers included
- Pull Out: 1000 lbs.
- Shear: 3000 lbs.
- Drill Size: 3/8"
|
|
INSTALLATION PROCEDURE:
|
1. Drill hole proper diameter
|
 |
2. Insert Anchor with nut and washer attached.
|
 |
3. Gravity turns retaining bar.
|
 |
4. Tighten nut until anchor is set
|
 |
|
Where do I use T-Anchors?
Signs & Awnings - Railings & Guard Rails - Overhead
Doors
Light Fixtures - Electrical Boxes - Shelving Brackets
- Cable TV Units
Any Hollow Wall or Ceiling Application! |
|
T-Anchors comply with these industry
standards
- Meets or exceeds G.S.A. Standards G.S.A. FF-B-588C
- Meets load factors in compliance with A.N.S.I. A58.1
- Meets plating standards in compliance with A.S.T.M. B-633
- Products tested in accordance with A.S.T.M. E-488.88
A safety factor of 4:1, or 25% of ultimate, should be used.
Critical applications (vibratory loads, overhead installations, etc.)
may require a safety factor of as much as 10:1 or more.
|
|
|
|
|